Publicidad
Idiomas disponibles
Idiomas disponibles
MAIN BURNER FLAME PATTERN
The Weber
®
gas barbecue burners have been factory set for the correct air and gas
mixture. The correct fl ame pattern is shown.
1)
Burner tube
2)
Tips occasionally fl icker yellow
3)
Light blue
4)
Dark blue
If the fl ames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures.
MAIN BURNER CLEANING PROCEDURE
Turn off the gas supply.
Remove the manifold (See "Replace Main Burners").
Look inside each burner with a fl ashlight.
Clean the inside of the burners with a wire (a straightened-out coat hanger will work).
Check and clean the air shutter opening at the ends of the burners. Check and clean
the valve orifi ces at the base of the valves. Use a Steel bristle brush to clean outside of
burners. This is to make sure all the burner ports are fully open.
CAUTION: Do not enlarge the burner ports when cleaning.
REPLACING MAIN BURNERS
®
1)
Your Weber
gas barbecue must be OFF and cool.
2)
Turn gas OFF at source.
3)
To remove control panel:
(a)
Take off the burner control knobs.
(b)
Remove screw and washer from back of control panel with a Phillips
screwdriver.
(c)
Tilt the back edge of the control panel up. Push in on the front edge to release
locking tabs.
(d)
Disconnect the igniter wires from the ignition module.
(e)
Carefully pull control panel away from frame.
4)
Remove the two nuts (a) that hold the manifold support bracket to the cooking box.
Allow the manifold support bracket to pivot down away from the cookbox, releasing
the valve assembly from the burners (b).
WWW.WEBER.COM
®
MAINTENANCE
a
c
a
b
17
17
b
e
d
Publicidad
