Descargar Imprimir esta página

RIDGID R40401 Manual Del Operador página 15

Sierra para losas y pavimento de 203 mm (8 pulg.) con láser

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
 Place the wheel wrench on the arbor nut then slide the
6 mm hex wrench into the arbor.
 Holding the hex wrench firmly to prevent movement, turn
the wheel wrench counterclockwise to loosen.
 Remove the arbor nut and outer washer, leaving the inner
washer on the arbor.
WARNING:
If inner washer has been removed, replace it before
placing wheel on arbor. Failure to do so could
cause an accident since the wheel will not tighten
properly. Never use wheels that have openings,
grooves, or teeth on this tool.
 Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
NOTE: Two water nozzles come installed on this product. Be
sure to install cutting wheel so that there is a water nozzle on
each side of cutting wheel with water ports facing the cutting
wheel. The outer water nozzle can be easily removed for
installation of cutting wheel. Check that outer nozzle outlet
hole has been reattached with water port facing toward the
cutting wheel.
 Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
 Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
INSTALLING SPLASH GUARD ASSEMBLY
See Figures 12 - 14.
The splash guard on this saw is a two-part assembly.
Attaching rear splash guard:
 Line up rear splash guard holes with screw hole and post
on back of cutting wheel guard, as shown.
SCREW HOLE
POST
 Insert screw through washer and splash guard then thread
 Tighten securely. Be careful not to overtighten.
Attaching side splash guard:
 Install side splash guard over the rear splash guard.
 Insert post, located on side of cutting wheel guard,
 Settle splash guard grooves over ridges in cutting wheel
 Repeat with other side.
 After assembly is complete, pull rear splash guard
WASHER
SCREW
REAR SPLASH
GUARD
Fig. 12
15 — English
into screw hole.
through hole in side flap of guard.
guard.
outward so flaps rest over side splash guard.
RIDGE
POST
SIDE SPLASH
GUARD
GROOVE
HOLE
SIDE SPLASH
GUARD
REAR
SPLASH
GUARD
Fig. 13
REAR SPLASH
GUARD
Fig. 14

Publicidad

loading

Este manual también es adecuado para:

R4040