RIDGID R40401 Manual Del Operador página 23

OPERATION
MAKING GARDEN PAVER CUTS
See Figures 28 - 31.
Garden pavers require special cuts to make curves and
corners in walls, patios, and other landscaping features.
To cut paver shorter:
 Measure paver to determine how much material needs
to be removed.
 Using a marker or grease pencil, make two marks, marking
all the way around the paver.
 Place the material on the table and firmly against the
fence.
NOTE: It may be necessary to remove side splash guard
to make room for paver cut.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the on/off switch to the on position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence
and feed the material into the cutting wheel.
 When the cut is made, turn the saw off. Wait for the cutting
wheel to come to a complete stop before removing any
part of the material.
 Move the sliding table away from the motor head and
turn paver over to make through cut.
Fig. 28
23 — English
NON- THROUGH
CUT
Fig. 29
THROUGH CUT
Fig. 30