Descargar Imprimir esta página

Cuda surgical EX400 Manual De Usuario página 21

Iluminador de xenón con regulador de luminosidad digital

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 87
10.
TROUBLESHOOTING
Problem
Power indicator (refer to 4.2)
is not lit.
Power indicator is lit, but
Xenon lamp will not ignite.
11. CHART OF MEDICAL AND ELECTRICAL DEVICE SYMBOLS USED
11.1 Chart of Medical Device Symbols Used
11.2
Chart of Electrical Symbols Used
®
LIT-238 CUDA
SURGICAL
(English)
Solution
• Check that the AC power cord is properly connected.
• Check power input switch position.
• Check the circuit breakers. If necessary, reset.
If any inoperable fault condition is displayed on the screen, correct
the condition shown per section 6.2.1.
Manufacturer
Date of manufacture (YYYY-MM-DD)
"Authorized Representative" in the
European Community
Caution
Caution: Federal law restricts this device
to sale by or on the order of a licensed
healthcare practitioner
Consult Instructions for Use
CE mark
Not disposable in general waste,
Caution: Hot Surface
Caution: Dangerous Voltage
Product Safety Mark
Do not use if package is damaged
AC Current
Equipotentiality
Power on
Power off
Type BF
Protective Earth (Ground)
Rev. -
Date of Revision: 06/08/18
Page 21 of 147

Publicidad

loading