Publicidad
Idiomas disponibles
Idiomas disponibles
About the temperaturecontrols.
GEAppliances.com
j-
The temperature controls are preset in the factory at 37°1:for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
Tochange the temperature, press and release the
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set temI)eratm'e.
To change
tile temperatm'e,
tap either
tile
WARMER or COLDER
pad
until tile desired
temperatm'e
is displayed.
Refl'igerator
temperatm'es
can be ac!justed between
34°F and 44°F and tile
fl'eezer temperatm'es
can be ac!iusted between
-6°F and +6°E
Once tile desired
temperature
has been set,
tile temperatm'e
display will retm'n
to tile actual
refl-igerator
and fl'eezer
temperatm'es
after 5
seconds.
Several
ac!iusnnents may
be required.
Each time you
a(!itlSt
controls,
allow 24 hotli's t0I" tile
refl-igerator
to reach
tile temperatm'e
you have set.
Toturn the cooling system off,tap tile WARMER pad
for either
tile refl-igerator
or tile fl'eezer
tmtil tile
display shows OFF. To turn the unit back on, press tile
COLDER pad
fin" either
tile refrigerator
or fl'eeze_:
The SETlight will illuminate
on the side w)u
selected.
Then
press the COLDERpad again
(on the
side where
the SErlight
is illuminated)
and it will
go to tile preset
points
of O°Ftor tile fl'eezer
and
37°ElOr tile refl-igerato_:
Setting either
or both
controls
to OFFstops cooling
in both the fl'eezer
and refrigerator
compartments,
but does not shut
off electrical
power to tile refl-igerato_:
Performance Ak FlowSystem
Tile Perl0mmnce
M>Flow System is designed
to
maximize
temperature
control
in tile refrigerator
and fl'eezer
comparmlents.
This unique
special
teatm'e
consists _ff tile Mr Tower along tile back
wall of tile refrigerator
and tile Mr Tmmel
on tile
bottom
portion
of tile fl'eezer
rear wall. Placing fi_od
in fl'ont ot tile louvers
on these components
will not
affect pe_fommnce.
Mthough
tile Mr Tower and
tile ?dr Tmmel
can be removed,
doing so will affect
temperatm'e
pedomlance.
(For removal
instructions,
on-line,
24 horn's a da> contact
us at
GEAl)pliances.com
or call 800.GE.CARES.
In
Canada,
contact
us at geappliances.ca
or call
1.800.361.3400.)
Publicidad
