Celexon HomeCinema Plus Manual De Instrucciones página 29

SETTING UP THE SCREEN WITHOUT BRACKETS
You can also place the screen free-standing on the floor or on furniture. Care-
fully put the screen down with the help of the transport handles on the side.
There are 4 feet on the underside of the screen. Align the screen to be level in
all directions using the adjustable feet. The picture should always be aligned
first using the setting options of your projector.
If necessary, correct the image alignment using the adjustable feet of the
screen. All 4 adjustable feet must always be in contact with the floor.
Note: If you do not need the adjustable feet for reasons of space in your instal-
lation, you can remove them completely from the housing. Make sure that the
screen is always level and rests on the outer and central support points.
Now that the screen is in its final place on the brackets, connect the power
supply to the screen and extend completely. Now check the angle between
the screen and your wall and use the Allen key to adjust the adjustment screws
on the two L-brackets until the fabric is perfectly straight and parallel to the
projection. You can adjust the brackets up to +/- 1.5° (fig.2).
This completes the basic installation of your screen. Finally check again that all
the parts are tightened firmly (hand-tight, no cordless screwdrivers!) and that
the screen is securely in place and that the brackets are holding tightly to your
supporting structure.
9