Nederman FilterBox M Manual De Usuario página 23

Thank you for using a Nederman product!
The Nederman Group is a world-leading supplier and
developer of products and solutions for the environ-
mental technology sector. Our innovative products
will filter, clean and recycle in the most demanding of
environments. Nederman's products and solutions will
help you improve your productivity, reduce costs and
also reduce the impact on the environment from in-
dustrial processes.
Read all product documentation and the product iden-
tification plate carefully before installation, use, and
service of this product. Replace documentation imme-
diately if lost. Nederman reserves the right, without
previous notice, to modify and improve its products
including documentation.
This product is designed to meet the requirements
of relevant EC directives. To maintain this status, all
installation, maintenance, and repair is to be done
by qualified personnel using only Nederman original
spare parts and accessories. Contact the nearest au-
thorized distributor or Nederman for advice on tech-
nical service and obtaining spare parts. If there are
any damaged or missing parts when the product is de-
livered, notify the carrier and the local Nederman rep-
resentative immediately.
This document contains important information that
is presented either as a warning, caution or note, ac-
cording to the following examples:
Warnings indicate a potential hazard to the
health and safety of personnel, and how that
hazard may be avoided.
Cautions indicate a potential hazard to the
product but not to personnel, and how that
hazard may be avoided.
Notes contain other information that is import-
ant for personnel.
• Do not install FilterBox close to heat sources.
• FilterBox is not intended for outdoor use.
• Store FilterBox indoors in a dry environment.
• Do not use the product for flammable or ex-
plosive dust and gases.
• Do not use the product in an environment
where there is a danger of explosion, or
where there is dust or gases in explosive con-
centrations.
• If the product has been used for dust applic-
ations, do not use it for welding fumes or
grinding dust.
• Do not use the product for extracting toxic
substances (except welding fumes).
• Do not use the product without filter cart-
ridge and casing.
• Only use the product in a well-ventilated
room.
• The air inlet and outlet must not be blocked
or used with any channelling equipment.
• Check that no sparks or other objects that can
cause fire are sucked into the arm. For weld-
ing applications generating a high amount
of sparks, spark protection (accessory) must
be mounted in the hood to reduce the risk of
fire.
• In case of fire, smoke from the product may
contain hazardous substances such as burn-
ing polycarbonate, PVC, polyethylene, etc.
Also, depending on the material being separ-
ated, hazardous smoke from the separated
dust may occur.
• In case of fire, disconnect power to the
product at the mains. Use a fire extinguisher,
minimum class AB.
Only properly trained personnel are allowed to
use this product.
For PTFE filter cartridge, weld only dry metals
with no oils.
Special requirements for EN ISO 21904-1:2020
compliance:
• Use Nederman original NANO or PTFE filters.
• The alarm must be set above the minimum
flow requirement for the hood.
• For TWIN, use only one arm at a time.
23