Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
CANCELLING THE PROGRAM
1. Press the Start/Pause button for 3 seconds to
cancel the program
2. After 3 seconds "1" will appear on the display.
During cancellation, the appliance discharges
the water inside for about 30 seconds.
NOTE
There might residues of detergent or rinse aid left in
the appliance and/or on the pieces being washed
depending on the cycle the programs was in when it
was cancelled.
RINSE AID INDICATOR
Check the Rinse Aid indicator light on the control
panel to confirm there is an adequate amount in the
appliance or not.
Fill the rinse aid reservoir with rinse aid whenever
the indicator light is illuminated.
END OF PROGRAM
The End of Program indicator light will illuminate
continuously when the washing program is over.
1. Open the door of the appliance.
2. Press the On/Off button to turn off the
appliance.
NOTE
Leave the dishes in the machine for about 15
minutes to cool down after they are washed. The
dishes will dry in a shorter time if the door of
the appliance is left ajar during this period. This
process will increase the drying effectiveness of the
appliance.
WATER CUT-OFF WARNING
If the water supply is turned off and the appliance
can not take water in, "FF" will flash continuously
on the display. As long as the problem continues,
the washing program is stopped.
Once the water supply issue is resolved, the
appliance is ready to start a new program.
OVERFLOW WARNING
If the appliance intakes too much water or there is a
leak with any of the components, the appliance will
detect this and "F1" will flash on the display. The
machine will continue to discharge the water and
flash the warning until the issue has been resolved.
If after attempting to resolve the issue and the
"F1" error does not disappear, please contact the
Consumer Service Department.
10
Publicidad
