Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
RINSE AID DISPENSER
Rinse aid can be used to prevent water droplets or
streaks from forming on dishes. The rinse aid will be
released automatically during the final rinse. This
dishwasher is designed to use liquid rinse aid only.
Do not use a powdered rinse aid as it will clog the
reservoir opening. Do not put any other substance
in the rinse aid dispenser as this can damage the
dishwasher.
The rinse aid indicator light on the control panel will
illuminate when the rinse aid dispenser is empty.
FILLING RINSE AID DISPENSER
• Open the rinse aid department cap.
• Fill the compartment to the MAX level.
• Close the compartment cap until it clicks.
Be careful to not overfill the rinse aid compartment
and wipe up any spills.
NOTE
Do not put detergent in the rinse aid dispenser as
this can damage the rinse aid dispenser and leave a
soap film on dishes.
To change how much rinse aid is being dispensed
with every wash, follow the steps below.
1. When the appliance is in the off position, press
the Program button and hold it down.
2. Turn on the appliance by pressing the On/Off
button and continue to press the Program button
until "rA" disappears from the display.
3. The appliance will display the last setting.
4. Set the level by pressing the Program button to
the desired level (see table below).
5. Turn off the appliance to save the setting.
NOTE
The factory setting is "4".
Level
Dose
r:1
no rinse aid
r:2
1 dose
r:3
2 doses
r:4
3 doses
r:5
4 doses
6
NOTE: If the dishes are
not drying properly or
are spotted, increase the
level.
If there are blue stains on
the dishes, decrease the
level.
Publicidad
