Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
WATER TEMPERATURE
Hot water is needed for best dishwashing and
drying results. Water entering the appliance should
be at least 120°F (49°C) to give satisfactory results.
To check the water temperature entering the
dishwasher:
• Turn on on the hot water faucet nearest the
appliance for several minutes to clear any cool
water from the pipes.
• Hold a candy or meat thermometer in the stream
of water to check the temperature.
• If the water temperature is below 120°F (49°C)
have a qualified person raise the hot water
heater thermostat setting.
PROGRAM SELECTION
1. Press the On/Off button to turn on the unit.
2. Refer to the "Programs Table" to determine a
suitable setting.
3. Press the program selection button until the
number of the program selected appears on the
display.
AUXILIARY FUNCTIONS
Auxiliary functions are provided in order to enable
savings of time, water and energy and to perform a
more comfortable washing with conditions specified
by you.
NOTE
Auxiliary functions may cause changes in the
program duration.
NOTE
Auxiliary functions are not suitable for all washing
programs. Indicator of the auxiliary function that
is not compatible with the program will not be
active. The unit gives aural warning via buzzer if an
auxiliary function is not compatible with a selected
programs. Please see the "Programs and Options
Table".
ADDING AUXILIARY FUNCTION
Select the desired washing program by pressing the
Program Selection button.
In the selected washing program if an auxiliary
function is selected, the corresponding indicator will
illuminate. If the Extra Function button is pressed
again, the corresponding indicator light of another
auxiliary function will Illuminate.
The selection of the auxiliary function can by
cancelled by pressing the Extra Function button six
times.
ULTRA-HOT FUNCTION
Raises the water temperature in the final rinse,
associated light will illuminate.
At the end of a successful cycle with Ultra-
Hot function, the "Ultra Hot End" indicator will
illuminate.
Available programs and options are indicated on
the Program Table and Options charts.
EXTRA DRY FUNCTION
The unit changes the water temperature from the
value described for each different program and the
extra dry is performed.
HALF LOAD FUNCTION
Used to operate the unit without loading it
completely.
1. Load dishes into the unit.
2. Turn the unit on with the On/Off button.
3. Select the desired program and press the
Options button one to activate the Half Load
function. The associated light will illuminate.
4. Press the Start/Pause button to start the selected
program.
5. The Half Load function can save power.
HI-TEMP FUNCTION
Press the Options button twice to activate the Hi-
Temp function. Use this specific option when using
combined detergents that contain salt and rinse aid.
When this option is selected, both the water
temperature and the washing time are increased.
8
Publicidad
