Makita CE003G Manual De Instrucciones página 12

PARTS DESCRIPTION
► Fig.1
1 Abrasive cut-off wheel /
diamond wheel
5 Battery cartridge
9 Lamp button
13 Cock
17 Box wrench (hex
wrench-shaped han-
dle tip)
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing the battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing the
battery cartridge. Failure to hold the tool and the
battery cartridge firmly may cause them to slip out
of your hands and result in damage to the tool and
battery cartridge and personal injury.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
To remove the battery cartridge, lift the battery cartridge
while pushing the button on the front of the cartridge.
► Fig.2: 1. Red indicator 2. Button 3. Battery cartridge
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not
fully installed, it may accidentally fall out of the tool,
causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
2 Wheel cover grip
6 Lock-off button
10 Switch trigger
14 Cover (for synchro-belt)
3 Wheel guard
7 Lamp
11 Handle
15 Shaft lock button
Indicating the remaining battery capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.3: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions.
Overload protection
When the tool/battery is operated in a manner that
causes it to draw an abnormally high current, the tool
automatically stops. In this situation, turn the tool off
and stop the application that caused the tool to become
overloaded. Then turn the tool on to restart.
12 ENGLISH
4 Grip
8 Overload indicator
12 Water inlet
16 Coupling sleeve
Off Blinking
malfunctioned.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have