Publicidad
Idiomas disponibles
Idiomas disponibles
5
BUTTON TO OPEN THE BATTERY COMPARTMENT.
6
BATTERY COMPARTMENT COVER.
7
MECHANICAL PRESSURE RELEASE.
8
BRIGHT CEMBRE LOGO, switches on automatically when the operating button is pressed, and
off after 5 minutes of non-operation. It allows the operator to have a visual feedback on the
pump status. It can flash or produce a fixed light with various colours depending on the mes-
sage emitted. The following table summarises the possible cases that can be found:
Lighting
steady
BLUE
pulsating
BLUE
steady
GREEN
flashing
RED
steady
ORANGE
pulsating
ORANGE
flashing
YELLOW
9
QUICK COUPLING (automatic locking, fitted with a fast-acting safety ring nut to eliminate any
risk of accidental disconnection).
10 CONNECTOR with cap, suitable to connect the remote controller.
11
Meaning
Pump powered and in stand-by
mode, ready to use.
Motor running and work cycle
in progress.
Correct completion of the
CRIMPING cycle carried out.
Incorrect completion of the
CRIMPING cycle carried out.
Scheduled maintenance re-
quired.
Motor running and work cycle
in progress, scheduled mainte-
nance required.
Fault in progress.
Note
Stays on until the "sleep" function is ac-
tivated. After 5 minutes of inactivity the
pump switches off automatically.
Flashes during the entire work cycle.
Lights up at the end of the cycle together
with the "OK" message on the display.
Lights up together with the "ERROR" mes-
sage on the display and an intermittent
audible alarm (see § 4.6 for further details).
Stays on until the "sleep" function is acti-
vated. It reappears each time the pump is
switched on until the scheduled mainte-
nance has been carried out and the cycles
have been simultaneously reset to zero.
Flashes during the entire work cycle.
Stays on until the anomaly has been
resolved, together with an indication on
the display and an audible alarm (see §
4.6 and 4.7 for further details).
Publicidad
