Publicidad
Idiomas disponibles
Idiomas disponibles
P
= 700 bar
n
P
= 701 bar
p
P
= 700 bar
n
OK
4.7) Alarms/Warning
P
= 700 bar
n
These appear on the display during the operation.
OK
They inform the operator about the state of the pump.
P = 0 bar
They may be accompanied by an audible signal and the CEMBRE logo (8) lit up yellow or orange.
P = 0 bar
Message
P
= 325 bar
p
BATTERY
P
= 325 bar
p
BATTERY
BATTERY
BATTERY
BATTERY
BATTERY
EMPTY
30001
BATTERY
BATTERY
EMPTY
BATTERY
BATTERY
BATTERY
30001
RESET
SW:S1J41405
30001
BATTERY
90°
RESET
SW:S1J41405
max 90°
RESET
30001
SW:S1J41405
90°
Lorem ipsum
Lorem ipsum
90°
max 90°
Lorem ipsum
RESET
BATTERY
max 90°
SW:S1J41405
Lorem ipsum
max.
90°
BATTERY
BATTERY
max.
max 90°
LED
max.
ON
30001
BATTERY
LED
LED
BATTERY
OFF
ON
BEEP
max.
LED
RESET
ON
SW:S1J41405
LED
OFF
5. MAINTENANCE
BATTERY
BEEP
LED
90°
OFF
LED
BEEP
The pump is robust, completely sealed, and requires very little daily maintenance. Compliance
max 90°
ON
with the following points, should help to maintain its optimum performance:
LED
OFF
5.1) Thorough cleaning
BEEP
BEEP
Dust, sand and dirt are a danger for any hydraulic device.
max.
Every day, after use, the pump and accessoires must be wiped with a clean cloth taking care to
BEEP
remove any residue. Do not use Hydrocarbons to clean the rubber parts.
BATTERY
BEEP
LED
ON
19
BEEP
LED
P =
0 bar
P =
0 bar
Meaning
P
= 547 bar
p
LOW
ERROR
P
= 547 bar
BATTERY
p
VERY LOW OR
ERROR
DAMAGED
001
ERROR
BATTERY
FULLY
002
DISCHARGE
001
ERCH ON
OR DAMAGED
ERROR
001
BATTERY
ERCH ON
003
002
BATTERY
ERCH OFF
TEMPERATURE
002
004
ERCH OFF
003
TOO HIGH
▲
001
OR TOO LOW
▼
003
004
002
MOTOR-PUMP
004
TEMPERATURE
003
HIGH
ERROR
min.
INSUFFICIENT
004
OIL
BATTERY
min.
001
LED
min.
OFF
BATTERY
REQUEST
002
MAINTENANCE
LED
LED
BATTERY
ON
OFF
min.
LED
003
OFF
LED
ON
BATTERY
004
LED
LED
ON
OFF
LED
ON
min.
BATTERY
LED
OFF
LED
BATTERY
30001
BATTERY
30001
BATTERY
BATTERY
RESET
BATTERY
SW:S1J41405
RESET
SW:S1J41405
90°
SW:S1J41405
RESET
SW:S1J41405
90°
max 90°
max 90°
Recharge the battery.
The motor does not start.
Recharge or replace the battery.
LED
max.
If the battery does not charge, it can be damaged.
BATTERY
ON
The motor does not start.
LED
max.
LED
ON
OFF
BATTERY
Recharge or replace the battery.
LED
OFF
If the battery does not charge, it can be damaged.
BATTERY
Lorem ipsum
When the battery voltage falls below a minimum safety threshold
the pump does not start.
Lorem ipsum
Remove the battery and wait until it cools down or warm up.
In order to cool it quicker, it is possible to insert it into the sup-
plied battery charger supplied, thus making use of the specific
"AIR COOLED" function.
The maximum permitted operating temperature of 90 °C (194 °F)
is reached. The motor stops; in this instance wait for it to cool.
Only when the permitted working temperature is reached will
it be possible to re-use the pump.
This appears when the pressure of the hydraulic circuit doesn't
BEEP
increase but remains near to zero for a duration of 30 consecu-
BEEP
tive seconds.
Check the oil level and if necessary refill (Ref. to § 5.4).
No. of cycles to maintenance reached; the pump continues to
work however, it is recommended that it is sent to CEMBRE for
a complete overhaul (Ref. to § 7).
This screen is associated with the orange color of the logo.
FAULT
001
ERROR
001
002
ERROR
001
002
30001
002
001
003
30001
003
002
RESET
003
004
003
004
90°
Description
max 90°
004
004
90°
max 90°
min.
max.
BATTERY
BATTERY
max.
min.
LED
min.
BATTERY
OFF
LED
min.
LED
OFF
ON
BEEP
BATTERY
LED
ON
BEEP
BATTERY
ERCH OFF
ERCH OFF
BEEP
ERCH ON
BEEP
ERCH ON
Publicidad
