Descargar Imprimir esta página

Medion MD 37763 Manual De Instrucciones página 116

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
9. Using the dishwasher
CAUTION!
Risk of injury!
There is a risk of injury due to improper use of the appli-
ance.
 Close the appliance door again after a wash cycle has
finished, as an open door could pose a trip hazard.
 Do not place any heavy objects on the door if it is
open. The appliance could tip forwards.
CAUTION!
Risk of burning!
There is a risk of scalding if hot surfaces are touched.
Hot water/hot steam can escape and cause burns if the
door is opened while a program is running.
 Allow the appliance to cool down before emptying. Do
not touch the heating element in the dishwasher dur-
ing or immediately after use.
 Only operate the dishwasher once the door has been
closed firmly.
 Do not open the dishwasher door fully straight away
– instead wait for about 3 seconds until the spray arm
stops rotating and then open the door.
Fig. 22 – Using the dishwasher drain
9.1. Switching on the appliance
To start the appliance, proceed as follows:
 Add the detergent, rinse aid and, if necessary, salt de-
pending on the desired program.
 Insert the dish rack and cutlery basket (6) (see section
"8.6. Loading the dishes and cutlery" on page 112) and
push the dish rack into the dishwasher.
 Plug the mains plug (24) into the socket. Turn on the
water supply fully or fill the water tank manually.
 Press the
button (23) to switch on the appliance.
Program P1 flashes and is displayed alternately with the
program duration.
114
 Press the program selection button
to select the desired program P1, P2 or P3 or press the
button
button
the button
lecting a wash program" on page 115). With the short
program, you can choose between hot (press 1x
and cold rinsing (press 2x
 You have the option of adding an extra rinse and/or an
extra dry cycle to the programs. Press the
ton (21) (see also "9.2. Extra rinse/extra dry").
The control light for the selected program lights up.
 Press the
While a program is running, the display panel shows the
current status:
• Segment display shows "-:--" – the appliance is in
standby mode
• Segment display shows "H:MM" – the program is inter-
rupted
• Segment display shows "H:MM" and flashes – the pro-
gram is running
• Segment display shows "END" – program completed
If you press the
the program is interrupted. The appliance sounds an
acoustic signal every minute.
P
 Press the
The program continues after approx. 10 seconds.
P
(22) several times
(16) for the glass cleaning program, the
(17) for the baby bottle cleaning program or
(18) for the short program (see "9.6. Se-
).
button (15) to start the program.
button while the program is running,
button again to continue the program.
)
/
but-

Publicidad

loading