Descargar Imprimir esta página

Medion MD 37763 Manual De Instrucciones página 123

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
15. Error messages
If there is a fault, the dishwasher displays an error code.
The following table shows possible error codes and their
causes.
Error
Problem
message
E1
If the predefined
amount of water
is not reached
after 4 minutes
during the water
inlet process or if
no water inlet is
detected after 60
seconds and 30
pulses, error E1 is
output.
E3
Wash temper-
ature is not
reached
E4
The appliance
overflows/leaks.
Ed
Error display on
control panel
Salt container is
empty
 If there is an error code that cannot be rectified, con-
tact Service.
Solution
 Check the water
supply
 Check inlet valve
 Check drain valve
 Flow rate measure-
ment, drain valve
or pump failure,
contact the service
department.
 Heating element/
thermistor error,
contact the service
department.
 Make sure that the
door is closed cor-
rectly and that the
water inlet and out-
let are connected
correctly.
 Turn off the water
supply.
 If water is on the ap-
pliance base due to
overfilling, remove
the water before
restarting the dish-
washer.
 Contact our Service
Centre.
 Replenish the salt
container
16. Disposal
PACKAGING
Your appliance has been packaged to
protect it from damage in transit. The
packaging is made of materials that can
be recycled in an environmentally friendly
manner.
Observe the following labels on the packaging
materials regarding waste separation with the ab-
breviations (a) and numbers (b):
1–7: plastics/20–22: paper and cardboard/80–98:
composite materials
(France only)
The "Triman" symbol tells the consumer that the
product can be recycled, is covered by an extend-
ed system of manufacturer's responsibility and
must be sorted by material type in France.
APPLIANCE
All old appliances marked with the symbol shown
must not be disposed of in normal household
waste.
In accordance with Directive 2012/19/EU, the appli-
ance must be properly disposed of at the end of
its service life.
This involves separating the materials in the appli-
ance for the purpose of recycling as well as min-
imising the environmental impact and negative
effects on human health.
Take old appliances to an electrical scrap collec-
tion point or a recycling centre.
Contact your local waste disposal company or
your local authority for more information on this
subject.
17. Technical specifi cations
Distributor:
MEDION AG
Am Zehnthof 77
45307 Essen
Germany
Model
MD 37763
Power supply
220–240 V~, 50 Hz
Power consumption
730–860 W
Capacity
up to 2 place settings (dia.
24 cm)
Inlet water pressure
0.04–1.0 MPa (0.4–10 bar)
Hot water supply
max. 60°C
Protection class
I
Net weight
13.5 kg
DE
FR
NL
ES
IT
EN
121

Publicidad

loading