Hisense HBD5A Manual De Instrucciones página 50

3. Open the top cover of the machine by pressing the button on the top cover with a force of 60-80N.
Put the keg, with the beer dispensing unit installed, into the cavity of the machine. Then connect the
adaptor with the tap connector.
Note: Keep the tap closed when connecting the beer dispensing unit to the tap connector.
4. Rotate the pressure reducing valve assembly from the bottom to the top at an appropriate angle,
with a maximum angle of no more than 90 degrees. Then unscrew the cartridge sleeve, install a 16g
Co2 cartridge (with 3 Co2 cartridges attached) into the cartridge sleeve, and carefully and quickly
tighten the cartridge sleeve (clockwise for tightness, counterclockwise for looseness) until a "click"
sound is heard, indicating that the cartridge sealant has been punctured and that Co2 gas can flow
freely. Then turn the pressure reducing valve assembly to its original position and insert it into the beer
dispensing unit. To replace the gas cartridge, follow the reverse steps (please ensure that the gas has
been fully used up when replacing the gas cartridge).
5. Following the previous steps, you can start using the beer function.
Replacing the beer keg
1. When the beer in the keg runs out, before changing to a new beer keg, open the tap and let the
excess gas out of the keg (this may be accompanied by some beer foam).
2. Take out the connector from the keg.
3. It is recommended to clean the tap mechanism each time you change the beer keg. Please refer to
the contents below regarding cleaning.
49