Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
First try the solutions
suggested
here
for assistance
and to possibly
avoid
a service
call.
Washer
won't run or fill,
washer
stops working
or wash light remains
on (indicating
that the
washer
was unable
to fill
appropriately)
Check for proper
water
supply.
Both hoses must be attached
and have water
flowing
to inlet
valve.
Both hot and cold water
faucets
must be turned
on.
Check that inlet valve screens have not become
clogged.
Check for any kinks in inlet hoses, which can restrict water
flow.
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow
these instructions can result in death,
fire, or electrical shock.
Washer
not draining/
spinning,
loads are
still wet or spin light
remains on (indicating
that the washer
was
unable
to pump out
water
within
10 minutes)
Check
proper
electrical
supply.
Normal
washer
operation.
Washer
may be tightly
packed.
Small
items may have been caught
in pump
or between
basket
and tub,
which
can slow draining.
Use a cycle with a low spin speed.
The washer
may be tightly
packed
or
unbalanced.
Plug power cord
into a grounded
3 prong
outlet.
Do not use an extension
cord.
Ensure there is power to outlet.
Reset a tripped
circuit
breaker.
Replace any blown
fuses.
NOTE:
If problems
continue,
contact
an electrician.
Lid must be closed for washer
to run.
Washer
will pause during
certain
phases of cycle.
Do not interrupt
cycle.
Remove
severalitems,rearrange load evenly in basket.Close lid
and press START/PAUSE/Unlock
Lid.
Do not add more than I or 2 additional items aftercycle has
startedto avoid tightlypacking or unbalancing.
Do not add more water
to the washer.
Empty
pockets
and use garment
bags for small items.
Cycles with
lower spin speeds
remove
Jess water
than cycles
with high spin speeds.
Use the recommended
cycle/speed
spin
for your garment.
To remove
extra water
in the Ioad_ select
Drain/Spin.
Load
may need to be rearranged
to allow
even
distribution
of the load in the basket.
Tightly packed
or unbalanced
loads may not allow the washer
to spin correctiy_
leaving
the load wetter
than
normal,
Evenly
arrange
the wet load for balanced
spinning.
Select the Drain &
Spin cycle to remove
excess water.
See "Using
Your Washer"
for
loading
recommendations.
13
Publicidad
