Publicidad
Idiomas disponibles
Idiomas disponibles
WASH
You will hear the motor and agitator
moving
the load.
During
the first stage of the sensing/wash
cycle, water
will
partially
fill the washer
and then begin to move the load.
It
is normal
to have the sensing
light on during
this stage. You
will hear the agitator
rotate,
followed
by a several
second
pause. This process will repeat for several
minutes,
allowing
the entire
load to become
saturated.
The lower water
level combined
with
HE detergent
at this stage allows
for
concentrated
cleaning.
Concentrated
cleaning
delivers
the
detergent
directly
to the soils. It is normal
for the load to
be above
the water
line during
this stage. At the beginning
of the second
stage, the washer
will add water
to the
correct
level based on the load size. You will hear the
agitator
move quicker
during
this stage of the wash cycle.
The motor sounds
may change
at different
stages in the
wash cycle.
RINSE
You will hear sounds similar
1o the wash cycle as the
washer
rinses and moves the load.
You may hear the
motor
turning
on briefly
(short hum) to move the basket
while filling.
COMPLETE
Once the cycle is complete,
this light will come on. Remove
the load promptly
for best results.
LiD LOCKED
To allow
for higher
spin speeds,
the lid
will lock and the Lid Locked
light will turn
on. When
this light is lit, the lid is locked
and cannot
be opened.
When
this light is
blinking,
the washer
is paused.
When
this
light is off, the lid can be opened.
START j
PAUSE i
CANCEL
UNOCK
LID
I
HOLD 3 sEc
After a cycle is started,
water
will enter washer.
Lid will be
unlocked
during
the Sensing/Fill
process.
If you need to
open
the lid to add a garment
after
this point, you must
press START/Pause
and wait for the lid to unlock.
The
lid will only unlock
after
washer
movement
has stopped.
Depending
on where
in the cycle you try to pause, it may
take several
seconds
to several
minutes
for the lid to
unlock.
Press START/Pause
to resume the cycle.
SPIN
The washer
spins the load at increasing speeds
for
proper
water
removal,
based
on the selected
cycle
and spin speed.
Publicidad
