Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
Grinding Wheel Capacity ........................................4-1/2 in.
No Load Speed ................................................... 9,000/min
Spindle Thread............................................5/8 in. x 11 UNC
UNPACKING
This product requires assembly.
„ Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
„ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
„ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
FEATURES
Recommended Grinding Wheel
Thickness......................................................Type 27, 6 mm
Recommended Cutting Wheel
Thickness......................................................Type 1, 1.6 mm
ASSEMBLY
INSTALLING/REMOVING GRINDING GUARD
See Figures 1 - 3, pages 13 - 14.
To install:
„ Place the guard on the shoulder of the bearing cap by
aligning index arrows on guard and bearing cap. Press
down on guard until it is fully seated.
„ Depress the lever and rotate guard to the correct position.
Refer to Positioning the Grinding guard.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap.
„ Install disc flange, grinding or cutting wheel, and clamp
nut as described later in this section.
„ Tighten clamp nut securely with the wrench provided.
To remove:
„ Remove the disc flange, grinding or cutting wheel, and
clamp nut.
„ Depress the lever and rotate guard to align index arrows
on guard and bearing cap.
„ Remove the guard.
INSTALLING/REMOVING GRINDING WHEEL
See Figure 1, page 13.
WARNING:
Thoroughly inspect a new grinding wheel before you
install it on the grinder.
• Tap lightly around the wheel using a wooden hammer.
• Listen carefully to the resulting sounds. Places with
fissures or cracks will result in a different sound.
Do not use a wheel containing fissures or cracks. When
you install a new grinding wheel, carry out a no load
revolution test of approximately one minute with the
grinding wheel facing a safe direction, i.e., away from
people or objects.
„ Install the grinding guard.
„ Place the disc flange onto the spindle. Make sure the
flats on the bottom of the disc flange are engaged with
the flats on the spindle.
„ Place the grinding wheel over the spindle.
7 — English
Publicidad
