Publicidad
Idiomas disponibles
Idiomas disponibles
2. Open the cover of the recovery tank.
3. Rinse the tank with a water jet.
SUCTION FILTER CLEANING
1. Open the cover (1) and unscrew the knob (2) to release the filter
protection (3).
2. Rotate the filter protection clockwise to release it.
3. Take off the filter and the filter
protection.
4. Clean all parts with a water jet
especially the inside surfaces and
the filter bottom.
5. Carry out cleaning operations
carefully.
6. Reassemble all parts.
MANUAL DISASSEMBLY OF THE BRUSHES
With the brushes base in lifted position, turn the brush in the rotat-
ing direction as indicated in the figure, until it is released from the
brush holder plate seat. The figure shows the rotating sense for the
release.
AUTOMATIC DISASSEMBLY OF THE BRUSHES
1. Turn the key (1) clockwise to switch on the machine.
2. Press the push button (2) of up/down brushes base to lift the
brushes.
3. Press and hold the push buttons (3) and (4) together and then
press and hold for 5 seconds the push button (2).
Move the machine before picking up the brushes in order to avoid
injuries.
BRUSH CLEANING
Disassemble the brushes and clean them with a water jet (check
under paragraph of "BRUSHES DISASSEMBLY").
SQUEEGEE CLEANING
Keeping the squeegee clean guarantees always the best drying
result.
For squeegee cleaning it is necessary to:
1. Take off the squeegee hose (4) from the coupling.
2. Disassemble the squeegee from its support (1) by loosening the
knobs (2) counterclockwise and sliding the threaded parts in the
appropriate slots up to their release.
3. Clean the internal part of the squeegee inlet to eliminate dirt
residue.
4. Clean the squeegee rubbers.
15
Publicidad
