DeWalt D28710 Manual De Instrucciones página 13

Troubleshooting Guide...
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT'S WRONG?
1. Fence not adjusted correctly.
2. Wheel is not square to fence.
3. Excessive force used to make cut.
4. Workpiece moving.
TROUBLE! CANNOT MOVE ARM
WHAT'S WRONG?
1. Chain lock is engaged.
TROUBLE! MATERIAL MOVES DURING CUT
WHAT'S WRONG?
1. Fence slipping or workpiece incorrectly placed or clamped.
2. Vise too loose.
3. Excessive cutting force.
WHAT TO DO...
1. Check and adjust. See Fence Operation on page 7.
2. Check and adjust.
3. Reduce cutting force; let the wheel do the work.
4. Clamp workpiece securely. See Material Clamping and
Supporting, page 6. Make sure material is laying flat against
the base.
WHAT TO DO...
1. Push down slightly on the arm, unlock the chain lock and
raise arm.
WHAT TO DO...
1. See Material Clamping and Supporting, page 6.
2. Tighten vise clamping.
3. Reduce cutting force.
12