Removal And Installation - DeWalt D28710 Manual De Instrucciones

Trigger Switch (Fig. 1)
To start the tool, depress the trigger switch (N). To turn the tool off,
release the trigger switch. Keep hands and material from wheel until
it has coasted to a stop.
To prevent unauthorized use of tool, install a standard padlock (not
included) into the padlock hole (O) located in the trigger.
Removal and Installation of Wheels
(Fig. 1, 7, 8)
_WARNING: Turn off and unplug the tool before making
any adjustments or removing or installing attachments or
accessories. Be sure the trigger switch is in the OFF position.
Do not make any adjustment while the wheel is in motion.
Do not make any adjustment while chop saw is plugged into
power supply.
1. Push in wheel lock lever (L) and rotate wheel (J) by hand until
wheel lock lever engages slot in inside flange (S) to lock wheel.
Loosen the bolt (T)counterclockwise in the center of the abrasive
wheel with the 8mm hex wrench (G). Bolt has right-hand thread.
2. Remove the bolt (T), washer (U), outside flange (V)and old wheel
(d).
3. Make sure flange surfaces are clean and flat. Install the new
abrasive wheel by reversing the above steps.
4. Do not overtighten bolt.
FIG.7
,_WARNING: Check the work surface that the chop saw rests on
when replacing with a new abrasive wheel. It is possible that the
wheel may contact ANY ITEMS OR STRUCTURE THAT EXTENDS
ABOVE work surface (under the base) when the arm is fully lowered.
FIG.8 J
V
Mounting (Fig. 9, 10)
_CAUTION: Tool must be supported on stable, level, non-skid
surface to prevent unexpected movement when operating.
PROCEDURE FOR PERMANENT MOUNTING
1. Drill two holes 5/16" (8 mm) FIG. 9 ,,................... ,
through the work surface o ,
i
(Fig. 9). ',
i
2. Insert 1/4-20 screws down ',
through the holes in the
base and through holes in
mounting surface. The
approximate length of
the screws should be the
thickness of the mounting
surface plus 4" (102 mm).
3. Tighten both screws securely.
................. /