Main Broom Replacement - Nilfisk-Advance Terra 4300B Instrucciones De Uso

ENGLISH

MAIN BROOM REPLACEMENT

NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
CAUTION!
It is advisable to wear protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level fl oor and engage the parking
brake with the pedal (3) and the lever (4).
2. Turn the ignition key (72) to "0".
3. Unscrew the knobs (23) and remove the right door (22).
4. Loosen the knob (A, Fig. 4).
5. Unscrew the knobs (B, Fig. 4) and remove the broom
compartment cover (C).
6. Remove the broom (A, Fig. 5).
7. Check that the drive hub (A, Fig. 6) is free from dirt or
foreign materials (ropes, rags, etc.) accidentally rolled up.
8. The new main broom must be installed with the bristles
rows (B, Fig. 6) bent as shown in the fi gure.
9. Install the new main broom (C, Fig. 6) and ensure that the
mesh (D) correctly fi ts into the relevant drive hub (A).
10. Install the broom compartment cover (C, Fig. 4) and
tighten the knobs (B) and (A).
11. Install the right door (22), then tighten the knobs (23).
12. Check and adjust the main broom height as shown in the
previous paragraph.
18
INSTRUCTIONS FOR USE
146 2810 000(2)2008-07
C
Terra™ 4300B
A
B
Figure 4
Figure 5
Figure 6
B
S311391
S311392
S311393