Peg-Perego prima pappa best Instrucciones De Uso página 9

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: READ THESE
INSTRUCTIONS CAREFULLY
AND KEEP THEM FOR FUTURE
REFERENCE. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD PUT
THE CHILD'S SAFETY AT RISK.
_ ALL ASSEMBLY AND OPERATING
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT; DO NOT
USE THE PRODUCT IF IT HAS BROKEN
OR MISSING PARTS.
_ PREVENT SERIOUS INJURY OR DEATH
FROM FALLS OR SLIDING OUT;
ALWAYS USE COMPLETE 5 POINT
SEATBELT; THE CHILD SHOULD BE
SECURED IN THE HIGH CHAIR AT ALL
TIMES, EITHER IN THE RECLINED OR
IN THE UPRIGHT POSITION.
_ ALWAYS USE THE CROTCH STRAP.
_ NEVER LEAVE THE CHILD
UNATTENDED; ALWAYS KEEP CHILD
IN VIEW WHILE IN THE HIGHCHAIR.
_ TRAY AND ACCESSORY TRAYS ARE
NOT DESIGNED TO SUPPORT THE
CHILD'S WEIGHT; TRAY IS NOT
DESIGNED TO HOLD THE CHILD IN
THE CHAIR.
_ ALWAYS USE THE HIGHCHAIR ON A
FLAT, HORIZONTAL SURFACE.
_ IT IS RECOMMENDED THAT THE HIGH
CHAIR BE USED IN THE UPRIGHT
POSITION ONLY BY CHILDREN
CAPABLE OF SITTING UPRIGHT.
_ BE CAREFUL OF WHERE YOU PLACE
THE PRODUCT. AVOID PLACING THE
CHILD NEAR SAFETY HAZARDS SUCH
AS ELECTRICAL CORDS, SOURCES OF
HEAT, OR FLAMES.
_ DO NOT PUT FINGERS IN THE
MECHANISM. MAKE SURE YOUR
CHILD'S ARMS AND LEGS ARE CLEAR
OF THE MOVING PARTS DURING
ADJUSTMENT.
_ USING ACCESSORIES THAT
HAVE NOT BEEN APPROVED BY
THE MANUFACTURER MAY BE
HAZARDOUS.
_ DO NOT USE THE PRODUCT NEAR
STAIRS OR STEPS.
_ BE CAREFUL NOT TO PLACE THE
PRODUCT NEAR SOURCES OF HEAT
OR FLAMES, SUCH AS GAS STOVES,
ELECTRIC HEATERS, ETC.
_ MAKE SURE THE BELT IS ATTACHED
PROPERLY.
_ DO NOT USE THE HIGH CHAIR
UNLESS ALL OF THE PARTS ARE
PROPERLY FITTED AND ADJUSTED.
NOTICE:
_ THIS ARTICLE MEETS OR EXCEEDS
ALL REQUIREMENTS COVERED IN
ASTM F404 STANDARD AND LATEST
REVISIONS.
INSTRUCTIONS
1 FITTING THE WHEELS: fit the two wheels
with brakes on the rear of the high chair
(fig_a) and the other two on the front (fig_c),
pushing in the direction of the arrows.
2 OPENING: when it is removed from the
packaging, the high chair is not in the correct
position for use (packing position). For use,
raise it up until it engages with a click at one
of the seven chair heights (fig_a). To open
the high chair, push the red side levers down
(fig_b) and push the back supports outwards.
3 Before using the high chair, remove the
spacers (fig_a) and lower the footrest (fig_b).
4 ADJUSTABLE FOOTREST: to adjust the
footrest, push the buttons on the sides (fig_a)
and move it to the required position (fig_b).
5 BRAKE: the rear wheels of the high chair are
fitted with brakes. To apply the brakes, lower
the levers on the rear wheels. To release them,
raise the levers. It is recommended that you
apply the brakes before carrying out any
procedures involving the high chair.
6 TRAY: to fit the tray, pull the lever underneath
it towards you (fig_a) while at the same time
inserting it onto the armrests, and push down
fully (fig_b). The tray is extendible to three
positions (fig_c). The third position (indicated
with red markings) should not be used and is
only for reclosing the tray.
_ To extend the tray, pull the lever under it
and pull the tray towards you into the first
position, repeating the operation to move it
into the second position.
_ To remove the tray, pull the lever and at the
same time push the tray towards yourself
until it disengages.
- 9 -