Manual Parameter Entry; Manual Rim Diameter Entry; Manual Distance Entry; Easy Alu Function - Snap-On EEWB330B Manual De Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.5.3 Manual Parameter Entry

In the event of automatic SAPE failure, the parameter
values can be input manually. See manual entry of rim
width in the previous paragraph.
Figure 22
D
W
O
Figure 23
4.5.3.0 Manual Rim Diameter Entry - Select the
Manual Diameter button. Read the rim diameter marked
on the sidewall of the tire (Figure 22 and 23). Press
the Diameter Button (D) and enter the measured rim
diameter by selecting the +/- keys until the desired value
appears in the display.
Select Enter to save selection.
Figure 24
4.5.3.1 Manual Distance Entry - Move the distance
SAPE Arm to touch the inner edge of the wheel where
weights are to be placed and observe the reading on
the scale of the distance SAPE. See Figure 24. Press
manual Wheel Offset button (O) followed by selecting
the +/- keys until value is displayed in the display window.
Select Enter to save selection.
NOTE: The parameter arm must be in the Home rest
position when the balancer is powered up.
4.6

Easy Alu FUNCTION

The Easy Alu function automatically recognizes the
desired weight location by placing the SAPE Arm in
the correct locations.
Note:
Alu 4 and Alu 5 are not included in the Easy Alu
function. They require manual setting by the operator.
4.6.1
Automatic rim dimension reading and
Alu P Mode selection
Preparations:
— Compensation run carried out, if necessary.
— Wheel correctly clamped.
Important: The OK indication and recommendation
for optimization, as well as the optimization procedure
itself, will only be accurate if the rim width is correctly
entered (Manual Input).
Automatic rim distance and diameter reading with
an internal SAPE Arm
— Move the SAPE Arm into position on the rim to select
the initial weight application position (internal rim
side). Keep it in this position until an audible signal
is heard.
Figure 25
Only for Alu2P and Alu3P (Fig. 25):
— Position and hold the internal SAPE in the second
position on the rim to select the application
position on the right side of the rim.
Shortly afterwards the machine emits an audible
signal to indicate that the machine automatically
saves the weight application coordinates.
— Move the SAPE Arm to the idle position.
At this point you can change the Alu mode suggested
by the machine, using the "Easy Alu Toggle" function.
Do this by pressing the button
— Spin the assembly.
EEWB330B
once.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido