Procedure To Follow If A User Key Is Lost; Standard Operation; "Do Not Disturb" Function - hafele DT 100 Instrucciones De Funcionamiento

Ocultar thumbs Ver también para DT 100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

7. Clearing locking authorisation
7.1 Clearing the
locking
authorisation of
individual keys
7.2 Procedure to follow
if a user key is lost
8. Operation
8.1 Standard
operation
8.2 "Do not disturb"
function
14
• Privileged user keys
Privileged user keys have the same rights as normal user keys, but can also open
doors with the "do not disturb" function activated.
For step-by-step instructions "Allocating locking
authorisation - privileged user keys" see illustrations
starting on page 44.
• User keys with deadbolt lock function
User keys with the deadbolt lock function have the same rights as normal user
keys, but can set doors to "permanently open". Presenting any valid user key
locks the lock.
For step-by-step instructions "Allocating locking
authorisation - user key deadbolt lock function" see
illustrations starting on page 45.
For step-by-step instructions "Clearing locking
authorisation - individual user keys" see illustrations
starting on page 47.
If a user key has been lost, the category to which the lost user key belonged must
be determined (normal user key, privileged user key or user key with deadbolt lock
function).
Then all user keys in this category must be cleared at the affected door terminals.
• For normal user keys:
For step-by-step instructions "Clearing locking
authorisation - normal user keys" see illustrations
starting on page 48.
Then locking authorisation must be allocated to all of the required user keys again
(see chapter "6. Allocating locking authorisation").
From the inside:
• Open door using lever handle.
The door can be opened from the inside at any time using the lever handle.
From the outside:
• An authorised user key is needed to open the door from the outside.
For step-by-step instructions "Operation" see
illustrations starting on page 49.
The "do not disturb" function is used as follows::
• The guest turns the thumbturn on the inside of the fitting to the horizontal position
(similar to locking a normal lock).
• The "do not disturb" function has been activated.
• The door can be opened from the inside by pushing the lever handle.
• If personnel with normal user keys attempt to open the door from the outside, the
LED flashes three times in blue. The door cannot be opened.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dt 100 fh

Tabla de contenido