Bio Bronpi Radiofrecuencia Serie Instrucciones De Instalación, Uso Y Mantenimiento página 35

8.4 SEALS OF THE COMBUSTION DOOR AND THE GLASS FIBRE
The seals of the door and the glass fibre guarantee the hermeticism of the stove or insert and, thus, a proper
performance (see drawing D39).
It is necessary to check them regularly; if they are worn-out or damaged they should be replaced
immediately. You can find ceramic cord and self-adhesive fibre at the same Bronpi distributor where you
bought your stove.
These operations should be done exclusively by an authorised technician.
An authorised technician must do the maintenance at least once a year.
8.5 CLEANING THE CHIMNEY
When the pellet is burnt slowly, it produces tar deposits and other organic vapours that combined with the
humidity to create soot (creosote). An excessive accumulation of soot may cause problems in the smoke outlet and the flue may catch fire if
not maintained.
The cleaning of the stove chimney should only be made when the equipment is cold. A chimney sweep should perform this task and, at the
same time, examine the smoke duct (it is recommended to write down the dates of every cleaning and keep a register of them).
8.6 CLEANING THE GLASS
IMPORTANT:
Clean the glass only when it is cold in order to avoid possible explosion. You can use specific products. You can find
Bronpi vitro ceramic-cleaning product in the same Bronpi distributor where you bought your stove (see drawing D40).
BREAKAGE OF GLASSES. The glasses, as they are vitro ceramic, resist until 750ºC and they are not subject to thermal
shocks. The breakage can only be caused by mechanical shocks (crashes or violent closing of the door, etc). Therefore,
its replacement is not included in the warranty.
8.7 EXTERNAL CLEANING
Do not clean the external surface of the stove or insert with water or abrasive products because they may damage the stove. Use a feather
duster or a rag a bit wet.
8.8 CLEANING THE REGISTERS
To keep the validity of the guarantee it is mandatory to do the register cleaning by an technician authorised by Bronpi
Calefacción, who will write down the statement made.
It involves cleaning the ashes register of your stove or insert such as smoke zones.
First of all you must clean the whole inside of the
combustion chamber, removing the inside plates
of the stove or insert because of the soot uses to
accumulate on walls and it difficult the thermal
exchange. To do it, you must unscrew the central
screw and remove the plates with caution. Then,
brush the surfaces with a wire brush to clean the
dirtiness (see drawing D41).
In models Agatha, Alexia, Alicia, Agatha Extra,
Alicia Extra, Clara Extra, Cleo Extra and Olivia Extra
it is also necessary to clean the heat exchanger
chamber, because the soot on the upper part
makes difficult the smoke circulation. To access to
this zone you must remove the ceiling of the stove
and then do the following operations:
- Unscrew the screws on each side of the cover on the top of the stove in order to access to the register. drawing D42.
- Remove the register cover unscrewing the two screws. drawing D43.
- Clean the ashes deposited on the top. drawing D44.
- Replace all the pieces and check the staunchness of the register.
D42
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D43
34
D44
RADIOFREQUENCY SERIES
D39
D40
D41