Seasonal Stoppages - Bio Bronpi Radiofrecuencia Serie Instrucciones De Instalación, Uso Y Mantenimiento

Once the top is clean, it is necessary to clean the smoke register placed on the bottom of the stove. To do this, it is necessary to open the
stove door (see drawing D45) (depending on the stove model at the place of opening the door it will must remove the frontal decorative plate
in order to access to the register) and then, follow the next operations:
- Remove the register cover unscrewing the different screws. See drawing D46
- Clean the ashes deposited on the register, descale the soot deposited.
- Cleaning the extractor forks and case. Remove the extractor if necessary. See drawing D47.
- Replace all the pieces and check the staunchness of the register.
D45
In the insert model Neva, for the cleaning of the smoke zone, please remove the inside plates of the insert and pick up the rear plate (see
drawing D48). The registers placed on the bottom of the combustion chamber must be also cleaned, one on each side of the burner (see
drawing D49) and the register annex to the smoke extractor, which can be accessed from the rear of the insert, slipping the insert off over the
guides (see drawing D50). In both cases, follow the next operations:
- Unscrew the screws to remove the register cover. See drawing D51
- Clean the ashes deposited on the register, descale the soot deposited.
- Replace all the pieces and check the staunchness of the register.
D48
In the insert model Damasco, for the cleaning of the smoke zone, please remove the inside plates of the insert and remove the register cover
placed on the rear side (see drawing D52). The registers placed on each side of the insert must also be cleaned. To do this, please remove
previously the protector sheet of the insert (see drawings D53 and D54). In both cases, follow the next operations:
- Unscrew the screws to remove the register cover.
- Clean the ashes deposited on the register, descale the soot deposited.
- Replace all the pieces and check the staunchness of the register.
D52
8.9

SEASONAL STOPPAGES

If the stove or insert is not going to be used for a long time it is advisable to keep the fuel tank empty, such as the screw-type conveyor
to avoid the fuel compacting. Clean the stove and the smoke duct, removing the ashes and other residues and close the stove door. It is
recommended to clean the chimney at least once a year. Meanwhile, check the seals because if they are not in good condition (they do not
adjust to the door), they do not guarantee the proper operation of the stove! For this reason, it would be necessary to change them. If there
is humidity in the place where the stove or insert is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral
vaseline in order to keep the appearance overtime.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D46
D49
D51
D53
35
D47
D50
D50
D54
RADIOFREQUENCY SERIES