Descargar Imprimir esta página

SEVERIN TO 9677 Instrucciones De Uso página 10

Mini horno tostador

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
Do not position or operate the appliance
close to or underneath any wall-cupboards
or hanging objects such as curtains or any
infl ammable materials.
During operation, the appliance must
be placed on a heat-resistant surface,
impervious to splashes and stains. Do
not position the appliance on or near
hot surfaces, open fl ames or infl ammable
vapours.
Caution: the pizza stone becomes very
hot during use, and will only cool down
very slowly aft er the appliance has been
switched off and disconnected from mains
power. Th ere is a severe danger of burns in
any case of contact.
Always let the pizza stone cool down
completely before it is removed from the
appliance.
Caution: do not place aluminium foil or
anything similar between the grill rack and
the pizza stone. Place the stone directly
onto the rack.
Do not allow the power cord to touch hot
surfaces.
Do not let the power cord hang free.
Always switch off and remove the plug
from the wall socket
-
aft er use, as well as
-
in cases of malfunction, and
-
during cleaning.
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Th is appliance is intended for domestic use
only and not for commercial applications.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer
service
address can be found in the appendix to
this manual.
departments.
Th e
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
6-position switch settings
Upper heat
Upper and lower heat
Upper heat with hot-air convection
function
Upper and lower heat with hot-air
convection funcion
Upper heat with rotating spit
Upper heat with hot-air convection
funcion and rotating spit
Th e heating elements will only be switched
on once the timer is activated.
Timer
Th e timer can be used for either selecting a
certain cooking time (up to 60 minutes), or
for continuous operation.
To select continuous operation, turn the timer
switch anti-clockwise to its
turn the unit off , turn the switch to position
.
To pre-programme the cooking time, turn the
switch clockwise to the desired time.
To set a time of less than 10 minutes, turn the
timer to a somewhat higher setting fi rst and
then slowly turn it back to the desired time
setting. Aft er the pre-programmed time has
elapsed, an acoustic signal indicates that the
heating elements are switched off .
Indicator lamp
Th e indicator lamp lights up when the
appliance is switched on. It goes out once the
pre-programmed time has elapsed, or if the
switch is turned back to position
Rotating spit
Th e rotating spit is used with the upper heat
function; in addition, the hot-air convection
function can be selected.
Before the spit is used, always ensure that
the baking tray is properly inserted into
10
position. To
.

Publicidad

loading