SEVERIN SM 3717 Instrucciones De Uso página 8

Switch settings
The following settings can be selected:
P The appliance remains switched on as
long as the switch is depressed
0 The appliance is switched off
1 Low power
2 Medium power
3 Maximum power
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated once the blender jug is properly
locked in position.
Before removing the blender jug, make sure
that the control switch is in position 0. This
also applies when fitting the blender jug to
the motor housing. If the switch is not in its
off-position (0), the motor will start
immediately.
Ice crusher
This blender may also be used to crush ice.
Put the ice cubes into the jug, but do not fill
over the 750 ml mark, and switch the
appliance on. Once the ice cubes are crushed
to the desired size, switch the appliance off
and take out the ice.
Operation
- Fit the blender jug to the motor housing
with its handle on the right and lock it by
turning anti-clockwise into the operation
position.
- Put the liquid ingredients into the
blender jug. The jug has a maximum
capacity of 1750 ml. To avoid possible
foaming or spilling when processing
foamable or thin liquids such as milk, do
not fill the jug over the 1250 ml mark.
- Put the lid on. To add ingredients during
operation, the stopper in the centre of the
lid can be removed by turning it in an
anti-clockwise direction and then lifting it
off. Do not put any objects into the
blender jug while the appliance is
operating.
- Insert the plug into the wall outlet and
use the control switch to select the
required power setting. Depending on
the food to be processed, the appliance
may also be operated for short periods of
time with the pulse setting "P". Do not
operate when the blender jug is empty.
- After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug. To remove the jug, turn in
the opposite direction from that
described in the assembly instructions.
General Care and Cleaning
●
Always remove the plug from the wall
socket before cleaning the appliance.
●
To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse
them in water. The motor housing may
be wiped with a slightly damp, lint-free
cloth.
●
Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning,
and do not clean in a dish-washer.
- For cleaning after use, fill the blender jug
with approximately 1250 ml warm water
and a mild cleaning detergent. Let the
appliance run for a short period as
described in the section Operation. Then
rinse the blender jug, lid and stopper with
fresh water. All parts must me
thoroughly dried afterwards.
- The blade can be taken off for thorough
cleaning. To remove the blade, turn the
connecting collar anti-clockwise to
separate it from the blender jug. Use a
suitable cloth to grip the blade and
remove it together with its mounting
from the collar. Caution: the blade is
extremely sharp. Use a suitable brush to
clean the blade and replace it in the
collar. During re-assembly after cleaning,
ensure that the seal is properly seated. Fit
the collar back on the blender jug and
lock it by turning it firmly clockwise
8