Vermeiren Pluo Manual De Instrucciones página 12

EN
NL
4. Mount the front wheels (2x):
• Insert the tube ends of the wheel supports in
the frame-tube ends.
• Tighten both wheel supports firmly with the
socket screw (21).
• Verify that the fronts wheels are well secured.
5. Add the rear wheels:
• Only for 5" model: Mount both rear wheels
with brakes, see previous step.
• Only for 24" model: Insert the connection pin
(22) of one 24" wheel in the shaft housing on
the frame till a click is heard. Repeat this for
the second wheel.
• Verify that the rear wheels are well secured.
6. Adjust the parking brake (only for 24" model):
• Loosen two socket screws (24).
• Put the parking brake in braking position
(brake lever to the front).
• Slide the parking-brake support (23) till the
brake stop is pressed on the tyre.
• Tighten the two socket screws (24).
• Verify that the shower chair stays in position
when the brake is applied. If not, repeat the
adjustment.
• Repeat this for the second parking brake.
• Make sure that both brake supports (23) are
well secured.
7. To add footrest (6), see §6.3.
24
8
Pluo
2019-10
21
22
23