Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - SCHOLTES FN 36 XA Manual De Instrucciones

Care and maintenance

Switching the appliance off

GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully (see diagram).
2. Lift up and turn the small levers located on the
two hinges (see diagram).
(see diagram).
To replace the door, reverse this sequence.
24
F
3. (with glass panel fitted to
the inside of the door) Grip the
door on the two outer sides
and close it approximately
half way. Unlock the door by
F
pressing on the clamps F,
then pull the door towards
you, lifting it out of its slot
Inspecting the seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre (see Assistance). We
recommend that the oven is not used until the seals
have been replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal
Glass door
1. Remove the glass cover using a screwdriver.
2. Unscrew the light bulb and replace it with a
similar one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly (see diagram).

Sliding rack kit assembly*

A
Left
Right guide
guide rail
rail
B
C
*
Only available in certain models.
To replace the
oven light bulb:
To assemble the
sliding racks:
1. Remove the two
frames, lifting them
away from the spacers
A (see figure).
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.