Futurelight AS - 200 Advertising Scan Manual Del Usuario página 26

Adjusting the end of operation:
Press the Enter-button.
The display shows „Mo.Of". Now you can adjust the starting time for Monday. If you wish to select a different
weekday, press the Up/Down-buttons until the display shows the desired weekday and „Of".
Press the Enter-button.
Adjust the hour via the Up/Down-buttons.
Press the Enter-button.
Adjust the minutes via the Up/Down-buttons.
Press the Enter-button.
Remark: The adjusted operating periods can be called up via the Enter-button.
Delete the programmed operation periods:
Press the Enter-button.
The display shows „Mo.On". Now you can delete the starting time for Monday. If you wish to select a different
weekday, press the Up/Down-buttons until the display shows the desired weekday and „On".
Press the Enter-button.
Adjust the hour via the Up/Down-buttons to ** (between „23" and „0").
Press the Enter-button.
Checking the operating-hour-meter
Your Advertising Scan offers the possibility to check the operating hours of the projector..
Press the Mode-button.
Press the Up-button until the display shows „POTI".
Press the Enter-button. The display shows the operating hours in hours.
Press the Enter-button.
Remark: The operating-hour-meter cannot be resetted.
Checking the operating-hours of the lamp
Your Advertising Scan offers the possibility to check the operating hours of the lamp.
Press the Mode-button.
Press the Up-button until the display shows „POTI".
Press the Enter-button. The display shows the operating hours of the lamp in hours.
Press the Enter-button.
Resetting the operating - hours of the lamp
After exchanging the lamp, you should reset the operating hours of the lamp.
Press the Mode-button.
Press the Up-button until the display shows „LATI".
Press the Enter-button. The display shows the operating hours of the lamp in hours.
Hold the Function-button, press and hold the Down-button and press and hold the Enter-button. Hold these
buttons for approx. 2 seconds until the operating-hours reset to 0 and the display shows „000".
Adjusting the reset - intervals
This adjustment is needed if the operating hours of the device have been programmed and the projector is to be
run automatically for a longer period of time.
The stepper motors used in this scanner work with supreme precision and are extremely reliable. Nevertheless,
fast mirror-movements and repeated strobe-effects can adjust the motors slightly. In such cases, the motors
have to be trimmed in a reset. In order to avoid misplaced misplaced projections in the long run, you can adjust
the reset-intervals with this function.
Press the Mode-button.
Press the Up-button until the display shows „RETI" .
Press the Enter-button. The display shows the current setting (0.0h - 23.9h)
Remark: Please avoid the setting „0.0h", as the device will continuously reset.
Adjust the desired interval via the Up/Down-buttons.
Press the Enter-button.
Remark: We recommend that you always adjust 1 Reset - even if you have only programmed relatively
smooth program-runs.
The projector will then cancel the current program, reset and restart the program in the programmed intervals.
26