Futurelight AS - 200 Advertising Scan Manual Del Usuario página 29

Programming step 1
Press the Program-button.
Select the desired program via the Up-/Down-buttons.
Press the Step-button.
Remark: If a step has already been programmed, the settings of this step will be displayed.
Select the desired step via the Up-/Down-buttons. This is only possible if several steps are available.
Adjusting the PAN-movement:
The PAN-movement is the horizontal movement of the mirror.
Press the Function-button. The display shows P_ _ _ (and the current DMX-value).
Via the Up/Down-buttons, you can move the mirror to the left or to the right. By pressing the Up/Down-buttons
once, the mirror moves step by step. By holding the Up/Down-buttons, the mirror moves with a continued speed
and the display moves between 0 and 255. This number corresponds to the DMX-value of the current mirror
position. Please adjust the mirror to the desired starting position of your movement.
Adjusting the TILT-movement:
The TILT-movement is the vertical movement of the mirror.
Press the Function-button. The display shows T_ _ _ (and the current DMX-value).
Please adjust the desired setting via the Up-/Down-buttons (0-255).
Adjusting the gobo-wheel/slide-wheel:
The slide-wheel features up to 5 slides. With this function you can select the slides individually.
Press the Function-button. The display shows G_ _ _ (and the current DMX-value).
Please adjust the desired setting via the Up-/Down-buttons (0-255).
For the DMX-values, please refer to the table „Channel 4: Gobo-wheel/Slide-wheel" further below.
Adjusting the rotation:
After you have programmed the starting position of the movement, the slide/gobo may not always be projected
horizontally. In such cases, you can adjust the inclination angle of the projection via this function. Furthermore,
you can adjust the desired rotation.
Press the Function-button. The display shows R_ _ _(and the current DMX-value).
Please adjust the desired setting via the Up-/Down-buttons (0-255).
For the DMX-values, please refer to the table „Channel 5: Rotation" further below.
Adjusting the focus:
After you have programmed the starting position of the movement, the projection will not always be correctly
focussed. With this function, you can steplessly adjust the focus.
Press the Function-button. The display shows F_ _ _ (and the current DMX-value).
Please adjust the desired setting via the Up-/Down-buttons (0-255).
Adjusting the fade-in time:
The fade-in time is the time the device needs for moving from one step to another. The fade-in time is decisive
for the speed of the mirror-movement and for the focus. In the course of the mirror-movement, the device
automatically optimizes the focus.
Press the Function-button. The display shows M_ _ _ (and the current speed in seconds).
Please adjust the desired setting via the Up-/Down-buttons (00.1 - 25.5).
Remark: If the settings of one step changes too fast so that the setting seems to be omitted, you can
extend the projection time. Please program the step with the desired (short) fade-in time. Extend the projection
time by copying the same settings to the next step. Copy the steps as often as needed until the projection is long
enough.
Smooth PAN-movements:
This function can only be ajusted in the 16-bit-mode. This function enables to increase the resolution of the PAN-
movements even more, that the mirror can be positioned even more exactly. Per movement, the resolution can
be increased by up to 20 more microsteps.
Press the Function-button. The display shows PS_ _ (and the current setting).
Please adjust the desired setting via the Up-/Down-buttons (0-25).
29