Maintenance Maintenance And Inspection - Metabo HPT NT 50AE2 S Instrucciones Y Manual De Seguridad

English
2 Pull out the nose cap in the direction of the arrow as
shown in the diagram.
Attach to the tip of the push lever in the reverse order
of detaching.
Firing head
Push lever
Nose cap
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that di er from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 8).
WARNING
Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Remove all nails.
3 Release the lock lever and open guide plate.
4 Remove the jammed nail with a slotted-head
screwdriver.
5 Close guide plate and latch.
6 In case of frequent jam, contact a metabo HPT
authorized service center.
18
000Book_NT50AE2_US.indb 18 000Book_NT50AE2_US.indb 18
When not using the nose cap, attach to the storage area
in back of the magazine.
1 Disconnect
air hose
MAINTENANCE
2. Storing
When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach of children.
Nose cap
3
1 Disconnect
Lock lever
3
Guide plate
Guide plate
air hose
2018/03/22 15:09:06 2018/03/22 15:09:06