Cut Out Ductwork Opening In Cabinet; Mounting Downdraft With Recirculation Kit (Hddrec5Uc); Mount Downdraft In Cabinet - Bosch HDD80051UC Instrucciones De Instalación

INSTALLATION

Cut out ductwork opening in cabinet

1. Measure and mark where to cut the ductwork opening
in the cabinet based on the ducting option selected.
Use the dimensions in the illustration below to help plan
how and where to provide duct access through your
cabinet.
REAR CORNER OF
COOKTOP CUT-OUT
7
5 " /
8
(149 mm)
HOLE FOR
1 7 " x 19"
/
8
1
4 " / (48 mm x 483 mm)
8
(105 mm)
DUCT &
TRANSITIONS
21"
(533 mm)
4"
(102 mm)
21"
(533 mm)
centered
1½"
INSIDE
(38 mm)
CABINET FLOOR
Hole in Cabinet Floor
Dimension A
Using Flex Blower (Model DHG602DUC) &
8" (203 mm) round duct straight
down through cabinet fl oor.
(1½" /38 mm left of installation center line)
7¾ inches (197 mm)
2. Set downdraft into cabinet/countertop opening as far back
as possible and make sure it is level.
INSTALLATION
CENTER LINE
INSIDE
CABINET BACK
24¾" (629 mm)
4" (102 mm)
Measurements
in inches (mm).
3. Check that markings in cabinet line up with ducting coming
from downdraft.
4. Remove downdraft housing from cabinet.
CAUTION
Before cutting hole in cabinet for ductwork, check
for interference with fl oor joists, wall studs, electrical
wiring or plumbing.
5. Cut ductwork hole in cabinet - as well as holes in wall or
fl oor as necessary.
Mounting downdraft with recirculation
kit (HDDREC5UC)
If unit is to be installed using a recirculation kit, please
follow the installation instructions for the recirculation
kit (HDDREC5UC) prior to installing and mounting the
downdraft in the cabinet.

Mount downdraft in cabinet

A
1. Set downdraft into cabinet/countertop opening as far back
as possible and make sure it is level.
2 No. 10 x 0.500
WOOD SCREW
2. Extend support legs and attach to bottom of cabinet with
(2) screws through each leg. Tighten nuts.
If cabinet bottom is removed: Use blocks as spacers
between fl oor and support legs.
1
1
English 17