Before You Begin; Installation Review; Tools Needed; Parts Supplied - Bosch HDD80051UC Instrucciones De Instalación

BEFORE YOU BEGIN

Installation review

This downdraft system can be used to exhaust cooking
by-products such as heat, steam, and smoke that may
be created while cooking using gas or electric cooktops.
With its versatile design, there are six (6) basic discharge
options - left, right, rear, front, down and recirculation. It
is important to fi rst plan your installation. The purchase of
additional accessories to complete the installation may be
necessary.
It can be mounted in an island, peninsula, or conventional
wall location. The blower (purchase separately) and
electrical panel can be mounted to the downdraft unit,
inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic
steps:
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote
•
location.
Install the cooking appliance.
•
Install end caps to downdraft.
•
Check the operation.
•
NOTE: The high level of air fl ow of this appliance may
effect the gas fl ame on some types of gas cooktops. This
is NORMAL and will cause no harm, but can be corrected
by lowering the speed of the blower.

Tools needed

Measuring tape
•
Pencil
•
Phillips screwdriver no. 2
•
Nut drivers - 11/32" (8.7 mm), 3/8" (9.5 mm),
•
7/16" (11.1 mm)
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves
•
English 8

Parts supplied

1 Parts Bag containing:
2 - Screws,
2 - Screws,
no. 8-18 x .375
1/4-20 x .50
(9.5 mm) Phillips
(12.7 mm) Hex
Head
1 - Plastic installation
template
2 - End Cap Trim
(see page 13
1 - Electrical Panel 1 - Electrical Panel
1 - Special key 1 - Special key Installation instructions Installation instructions
Wiring diagram
8 - Wood Screws,
no. 10 x .50 (12.7 mm)
Phillips Round Head
)
2 - Support Legs 2 - Support Legs
2 - Upper Support 2 - Upper Support
Brackets Brackets
Use and Care guide
Downdraft Ventilator Housing