Best CP55IQ Manual De Uso página 9

10. INSTALL THE 10" ADAPTER (CP57IQT S )
ERIES ONLY
Using 2 no. 8 x 3/8" screws from parts bag, assemble the adapter on the top of the power pack.
M
OUNTING SCREW LOCATIONS
Seal all joints with metal foil duct tape to eliminate air leaks.
HJ0026
11. INSTALL THE 10" IN-LINE DAMPER
(CP57IQT CP57E S , )
AND ERIES DUCTED INSTALLATION ONLY
NOTE: For a non-ducted installation, do not install the 10" in-line damper.
Install 10" in-line damper inside the vertical ductwork that will be attached to power pack. Do not
10" min.
install in a horizontal ductwork or it will not open and close properly. Remove shipping tape if
recommended
present. Secure the damper to the duct with 3 no. 8 sheet metal screws (not provided). Ensure
damper opens and closes freely. Seal all joints with metal foil duct tape to eliminate air leaks.
HJ0073A
9