Power Management - Pioneer Elite FS-EB70 Manual De Instrucciones

> Before Start > Part Names

■ Power Management

Sleep Timer Allows the unit to enter standby automatically when the specified
time elapses. Select from "30 minutes", "60 minutes", and "90
minutes".
"Off (Default Value)": Does not turn the unit to standby
automatically.
Auto Standby This setting places the unit on standby automatically after 20
minutes of inactivity without any video or audio input.
(When "USB Power Out at Standby" or "Network Standby" is on,
this becomes the HYBRID STANDBY mode which reduces the
increase in power consumption to a minimum.)
"On": The unit will automatically enter standby mode ("ASb" will
stay lit).
"Off (Default Value)": The unit will not automatically enter
standby mode.
0 "Auto Standby" is displayed on the display of this unit and TV
screen 30 seconds before the Auto Standby comes on.
Auto Standby in HDMI Enable or disable "Auto Standby" while "HDMI Standby Through"
Standby Through is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
0 This setting cannot be set to "On" if "Auto Standby" is set to
"Off".
USB Power Out at Devices connected to the USB port are supplied with electricity
Standby even when this unit is in standby mode when this function is
"On". (Default Value is "Off")
0 When using this feature, power consumption increases even
when the unit is on standby, however, the increase in power
consumption is kept to a minimum by automatically entering
the HYBRID STANDBY mode, where only essential circuits
are operating.
46
> Install > Initial Setup > Playback
Network Standby When this feature is turned "On (Default Value)", you can turn on
the power of the unit via the network using an application that
can control this unit.
0 When "Network Standby" is used, the power consumption
increases even when the unit is on standby. However, the
increase in power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY mode, where
only the essential circuit is operating.
0 "Network Standby", which suppresses power consumption,
may be disabled when the network connection is lost. Use the
power button on the remote controller or the main unit to turn
the unit on if this happens.
Bluetooth Wakeup This function wakes up the unit on standby by connecting a
BLUETOOTH enabled device.
"On": Use this function
"Off (Default Value)": Do not use this function
0 Setting to "On" increases the power consumption even when
the unit is on standby. However, the increase in power
consumption is kept to a minimum by automatically entering
the HYBRID STANDBY mode, where only the essential circuit
is operating.
0 This setting is fixed to "Off" if "Network/Bluetooth" -
"Bluetooth" - "Auto Input Change" (
0 Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It will
appear when the network feature is started.
Advanced Setup | Firmware Update | Others
P51) is set to "Off".
E
N