Wait until the appliance stops.
Pull out the mains plug.
7.
Emptying the bowl
Tip: You can empty the bowl during
processing without removing the con-
tinuous feed shredder.
Set the rotary switch to
1.
Wait until the appliance stops.
Press the release button and raise
2.
the swivel arm until it engages.
→ Fig.
17
Turn the bowl clockwise and re-
3.
move.
→ Fig.
18
Empty the bowl.
4.
Removing the continuous
feed shredder
WARNING
Risk of injury!
Improper use may cause injuries.
Only attach and remove accessor-
▶
ies once the drive has stopped
and the appliance has been un-
plugged.
Rotate the continuous feed shred-
1.
der anticlockwise until it releases.
→ Fig.
19
Remove the continuous feed
2.
shredder from the base unit.
→ Fig.
20
Dismantling the continuous
feed shredder
WARNING
Risk of cutting!
The cutting discs have sharp blades
and edges.
Only take hold of the cutting discs
▶
by the edge.
Never touch the sharp blades and
▶
edges with bare hands.
Rotate the lid anticlockwise.
1.
→ Fig.
Markings
up.
Remove the lid.
2.
→ Fig.
.
Take hold of the disc holder by the
3.
shaft and take out of the housing
with the cutting disc.
→ Fig.
Take hold of the cutting disc by
4.
the edge and remove.
→ Fig.
Tip: Clean all parts immediately after
use so that residues do not dry on.
Cleaning and servicing
Cleaning and servicing
To keep your accessory working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
Dishwasher-safe components
Find out here which components can
be put in the dishwasher.
ATTENTION!
Some parts may be damaged if they
are put in a dishwasher.
Only put dishwasher-safe parts in
▶
the dishwasher.
Only use programmes that do not
▶
heat the water above 60 °C.
Do not wedge plastic parts in the
▶
dishwasher.
Dishwasher-safe:
¡ Housing
¡ Lid
¡ Pusher
¡ Disc holder
Cleaning and servicing en
21
and
must match
22
23
24
21