ELECTRIC MILK FROTHER
8
radiator, fire.
• Never put batteries into fire, as they may explode.
• Always remove the batteries if you do not use the appliance - this will prevent
damage to the appliance in the event electrolyte leaks out of the batteries.
• Remove spent batteries from the appliance immediately.
• Electrolyte may leak out of spent batteries, causing damage to the appliance.
• If any acid from a battery comes into contact with your hands, rinse them
under running water. If any gets into your eyes, contact a doctor. The acid
contained in the batteries may cause irritation or burns.
TURNING THE MILK FROTHER ON AND OFF
1. To turn the milk frother on, press and hold the power switch situated on the
upper part of the frother.
2. To turn it off, release the power switch.
OPERATION
1. Before using the appliance, correctly install 2 batteries, as described in
Section 7.1. Battery insertion / replacement.
2. Boil some milk.
3. Pour the milk into the cup supplied.
4. Place the frother in a cup with boiled milk and press the on / off button to
start frothing the milk.
Attention! To operate the appliance, press and hold the power switch.
5. When frothing, systematically check the consistency of frothed milk and
adjust the frothing time to your individual preference.
6. After you have finished frothing milk, release the power switch.
7. The milk is ready for consumption.
Attention! A better foaming effect can be achieved by moving the frother up
and down.
CLEANING AND MAINTENANCE
Proper and regular cleaning will ensure safe operation and extend the life
span of the appliance.
1. Wipe the frother housing with a damp cloth.
2. Clean cup and lid with a detergent.
3. The agitator can be cleaned using a detergent.
4. Do not clean the appliance with corrosive or abrasive cleaning agents.
5. Make sure that you do not turn the appliance on whilst cleaning it.
6. The appliance is not waterproof. Do not clean it with running water and do
not immerse it in any liquids.