Maintenance - Hoover Onepwr BH55210 Manual Del Usuario

• High mode will give the optimal performance for large
mess pick up. ECO mode will give optimal battery run
time for standard cleaning.
• Engage the trigger on the handle to dispense solution as desired.
Brush roll will spin and unit will vacuum on both forward and back-
ward passes.
• To clean dried messes on hard floors, use trigger to
spray solution onto dried mess and allow to sit for 1-2
minutes. Pass the brush roll over mess until removed.
CAUTION!
Use for picking up small liquid spills (one gallon or less,
never to exceed 1/8" in depth).
•
CAUTION!
When cleaning hard floors, ensure flooring surfaces have
been sealed. Do not use on unsealed surfaces.
CAUTION!
Before cleaning area rugs, check manufacturer's tag for
cleaning instructions. Not for use on delicate fabrics.
Before use, check rug for colorfastness.
This product contains no serviceable parts.
If appliance is not working as it should, has been dropped,
damaged, left outdoors or dropped in water, contact cus-
tomer service at 800-406-2005.
Rinse Brush Roll and Flush Nozzle
See Figure 8, page 11
WARNING!
RISK OF PERSONAL INJURY-BRUSHROLL MAY SUDDENLY
RESTART-TURN POWER SWITCH OFF AND REMOVE BAT-
TERY BEFORE CLEANING OR SERVICING.
• Place unit on tray
• Fill the included measuring cup with water to max line (5 oz.).
• Pour water into rinse and storage tray.
• Recline handle and turn unit on to HIGH mode.
• Run for 10-15 seconds until water is extracted from tray.
• Repeat as needed until brush roll is rinsed and debris is
cleared from nozzle.
PG.5
OPERATION (CONTINUED)
Emptying the Dirty Water Tank
See Figure 7, page 11
To reduce the risk of personal injury, turn power switch
off and remove battery pack before cleaning or servicing.
• When full, the float in the dirty water tank will rise and
there will be an audible change in the operating sound.
• Empty the dirty water tank promptly. Continuing to clean
with a full tank may impact performance.
• To remove the tank, press down on the release latch on
the front of the tank and pull the tank away from the unit.
• Grasp the lid by the handles and lift.
• Empty the tank and rinse.
• Replace lid and install tank into body by aligning the
bottom of the tank and pushing back into the unit until
it clicks.
• Ensure float is installed correctly and can slide freely in dirty
water tank before any wet pick-up operation.
When vacuuming liquid, make sure the product does not
get submerged or doused in liquid, which could cause
shock, product failure, or personal injury.

MAINTENANCE

Water will drip from the brushes and underside of the prod-
uct after use and may puddle. To avoid damage to wood and
laminate flooring and to avoid potential slip hazard after use
(A) do not leave the product on wood and laminate surfaces
and (b) place unit on provided storage tray to contatin drips.
WARNING!
WARNING!
CAUTION!