Cleaning And Sanitizing Procedures; Disassembly - Ugolini NHT 1 GL Manual De Instrucciones

10 -Restrictor cap: when the unit is used in Soft Drink mode it
is advisable to install the restrictor cap on the faucet outlet
in order to reduce the drink outflow (see figure 5).
5. 3 CLEANING AND SANITIZING
PROCEDURES
1 - C l e a n i n g a n d s a n i t i z i n g o f t h e d i s p e n s e r a r e
recommended to guarantee the conservation of the best
product taste and the highest unit efficiency. This section
is a procedural guideline only and is subject to the
requirements of the local Health Authorities.
2 - Prior to the disassembly and cleaning, the machine must
be emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position.

5. 3. 1 DISASSEMBLY

ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source.
1 - Remove cover from the bowl.
2 - On NHT 1P GL model remove the lateral tray by lifting its
outer side up and off the hook located on the opposite side
Ugolini S.p.A.
figure 5
(see figure 6).
3 - Remove the bowl by lifting its faucet side up and off the
fastening hooks (see figure 7) and slide it out (see figure
8).
NHT GL
figure 6
figure 7
figure 8
7