Vermeiren Inovys II E Manual De Instrucciones página 20

EN
NL
The push handles (16) and push bar (23) are connected and
can be adjusted in 7 different height positions:
1. Loosen both star knobs (31) on the handle supports and
remove them.
2. Adjust the height of both push handles simultaneously by
sliding them up/down in the supports. Make sure that
the holes on the inner/outer tube align.
3. Insert the two star knobs (31) in the supports and the
adjustment holes.
4. Turn the star knobs clockwise until they are finger-tight.
5. Make sure that the push handles are firmly secured.
3.4.3 Leg rest angle
1. Loosen the lever (62) at the rotation point.
2. Adjust the angle of the leg rest by lifting/lowering
the footplates (between 100° - 190°).
3. Retighten the lever (62) firmly by hand.
4. Repeat this for the second leg rest. Make sure that
both leg rests are firmly secured.
3.4.4 Tip cap height
1. Press and hold the spring button (63).
2. Slide the tip cap tube (64) in/out of the frame tube.
3. Release the spring button.
4. Repeat this for the second tip cap. Make sure that
both tip caps are firmly secured.
62
63
64
16
Inovys II-E
2019-02
Using your wheelchair
16
23
31
Adjusting push-handle height
Adjusting footrest angle
Adjusting tip cap height