Charging The Battery - Vermeiren Inovys II E Manual De Instrucciones

Table 1: Code of battery indicator
Indication code
GREEN, continuously ON
GREEN, blinking fast;
1 second ON, 1 second OFF
GREEN, blinking slow;
0,5 second ON, 4 seconds
OFF
ORANGE, blinking slow;
0,5 second ON, 4 seconds
OFF
ORANGE, continuously ON Indicates a failure. The battery may be disconnected or there is an electrical
Light indicator
continuously OFF

3.7.2 Charging the battery

To charge the battery:
1. FIRST connect the power adapter to a 230V AC power socket. The
indicator (66) goes on (green) to show that the adapter is powered.
If not, do not use the charger and contact your specialist dealer.
2. Plug the adapter plug (67) in the socket (68) of the charging point,
see Figure 16. Make sure that the recess of the plug slides over the
protruding part inside the socket.
3. Wait until the battery indicator light (66) turns green (capacity
above 70%) and keep charging during the next 10 hours.
4. Disconnect the power adapter.
5. Remove the power adapter from the socket, let it cool down and store it dry in the
pocket.
Battery is connected to power supply and is charging normally
(battery capacity between 70 and 100%).
• Keep the battery connected to the power supply until fully charged.
Battery is connected to power supply and is charging normally (battery
capacity below 70%).
• Keep the battery connected to the power supply until fully charged.
Normal discharge of the battery
(battery capacity between 25 and 100%)
Battery needs charging (battery capacity below 25%).
• Charge the battery.
problem.
• Contact your specialist dealer for support or replacement.
Battery protection is applied and operation is blocked/stopped when:
Overcurrent exists for more than 10 seconds
o
Low voltage may cause over-discharging.
o
This is when the battery capacity drops below 20%.
• Charge the battery.
23
Using your wheelchair
Meaning
EN
Inovys II-E
2019-02
NL
66