7. GENERAL TROUBLESHOOTING
Symptom
No output or
short output
Spitting fluid
Normal
Circuit breaker
or fuse keeps
blowing
Product does not
power up
Indicator
Possible Cause
Status
Red
Heater warming up
Red flashing
Air bubble in fluid line
Incorrect fluid
Blue
Blocked pipes
Failing part
Incorrect fluid
Blue blinking
Blocked pipes
Failing part
Incorrect fluid
Blue
Blocked pipes
Failing part
Blue
Normal
Excessive load on the
circuit
Short circuit along
the power lines
N/A
No energy on power
outlet
Loose or damaged
power cord
Blown fuse
Possible Action
Allow the product to warm up completely.
This should take less than 10 minutes.
Allow the product to warm up completely
Turn fog machine 45° to flatten out the bub-
ble and allow the fog fluid to flow properly
Turn off the product for 5 seconds, and then
turn it back on. Repeat as necessary. After
more than 10 attempts, contact Customer
Service.
Clean thoroughly with AMPRO® FCQ. For full
instructions, see Fogger Maintenance. Refill
with AMPRO® water-based fog fluid.
Contact Customer Service
Contact Customer Service
Clean thoroughly with AMPRO® FCQ. For full
instructions, see Fogger Maintenance. Refill
with AMPRO® water-based fog fluid.
Contact Customer Service
Contact Customer Service
Clean thoroughly with AMPRO® FCQ. For full
instructions, see Fogger Maintenance. Refill
with AMPRO® water-based fog fluid.
Contact Customer Service
Contact Customer Service
Normal function
Make sure that the total load does not exceed
the recommended capacity of the breaker or
fuse's nominal current
Check the power lines and power cords
Check power outlet
Change to another outlet
Check the power cord
Replace blown fuse with a good one of the
same type and rating
English version
P. 11
| Tecshow Stratus 1500