Connections, Operating And Display Elements; Operation - Cameo MOVOBEAM ZOOM 100 Manual De Usuario

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
POWER IN
Blue mains input socket. Operating voltage 100 – 240 V AC / 50 – 60Hz. Connection using the power cable supplied.
2
POWER OUT
White power output socket. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all connected
devices does not exceed the value specified on the device in amperes (A).
3
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
4
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
5
ILLUMINATED GRAPHIC DISPLAY
Displays the current operating mode and other system settings.
6
CONTROLS
MODE
Press MODE to access the system settings selection menu. Press repeatedly to go back to the main display.
UP and DOWN
Select individual items in the selection menu and sub-menus for system settings (DMX address, operating mode etc.). These controls allow
changes to be made to the value of a menu item as required, e.g. the DMX address.
ENTER
Press ENTER to access sub-menus in the selection menu so as to be able to make changes to the settings. Confirm changes by pressing
ENTER.

OPERATION

NOTE
When the lamp is correctly connected to the mains supply, "Welcome to Cameo" and the software version are shown on the display during
start-up and motor reset. Once this process is complete, the spotlight is ready for operation and the previously selected operating mode is
activated.
MAIN DISPLAY DMX MODE
The DMX mode (DMX 5 Ch, 16 Ch, 36 Ch) is shown in the top line of the display with the DMX start address clearly visible at the centre (in
the example: DMX 36 Ch and ADDRESS 001). As soon as the DMX signal is interrupted, the display begins to flash. When there is a DMX
signal again, the display will stop flashing.
DMX 36 Ch
ADDRESS
001
3 1
5
2 4
5