CARLO GAVAZZI WM20 Manual De Instrucciones página 16

Operation
To connect
the accessory
modules
For panel
mounting
To set
parameters and
configure the
system
16
8021572 | WM20 | © 2016 | CARLO GAVAZZI Controls SpA
Procedure
DANGER!
injuries. Disconnect the power supply and load
before connecting the accessory modules.
See "Installing the accessory modules" on page 18.
Drill a hole with the dimensions 91 x 91 mm in the panel and follow
the procedure shown in figure 9.
If using ..... then...
the keypad
see "Use: menu description" on page 16 and "Use:
of the main
how to work" on page 35
unit
1. Connect to the WM20 via a Modbus RTU or
UCS
Modbus TCP/IP communication port or via
software
optical port using OptoProg.
2. Modify the parameters from the settings menu
or load a default configuration in offline mode.
Live parts. Heart attack, burns and other