Running A Pulse Transmission Test; Resetting Maximum And Average Values - CARLO GAVAZZI WM20 Manual De Instrucciones

Running a pulse transmission test

If the digital output is configured to transmit energy consumption via pulses, a test
transmission can be run.
1. In the settings menu, enter the sub-menu Dig out 1 or Dig out 2 (depending on the
digital output concerned)
2. Ensure that the output is configured for pulse transmission (Function = Puls)
3. Define the pulse weight (Pulse weig) and test power (Power test)
4. To start the test, set Yes in the Out test page: the test is then run immediately.
5. To terminate the test, set No in the Out test page.
NOTE: during the test, another power value may be set if required. On confirmation of
the value, the test transmission is then updated.

Resetting maximum and average values

The analyzer calculates the maximum, average
measurements of active, apparent and reactive power and current. These values can be
reset in two ways, with or without password access.
Resetting with password access, from the settings menu
1. From any page in the measurement menu, enter the settings menu: the Password?
page is then displayed.
2. Enter the password and confirm.
3. Scroll through the pages to display the Reset page and enter the sub-menu: the
Reset max page is then displayed.
4. Modify the parameter and select the option YES.
5. Confirm the operation: the message "Saving" is displayed and the maximum values
of active, apparent and reactive energy are reset.
38
8021572 | WM20 | © 2016 | CARLO GAVAZZI Controls SpA
and average maximum value for