Making Network Settings Manually; Restarting The Network Unit; Naming The Unit (My Name Function) - Sony TDM-NC1 Manual De Instrucciones

Making network settings
manually
By default the TDM-NC1 acquires an IP address
automatically. Use the following procedure to
specify an IP address, if necessary. Note that
when the TDM-NC1 is used in an environment
containing a router with DHCP, you should not
need to specify the IP address of the TDM-NC1.
1
Select "NET SETUP?" in the network
menu (page 31), then press ENTER.
2
Press . or > repeatedly until
"NET TYPE?" appears, then press
ENTER.
3
Press . or > repeatedly until
"MANUAL?" appears, then press
ENTER.
"IP ADDRESS?" appears.
4
Press ENTER again.
The currently set IP address appears.
5
Press . or > repeatedly to enter
the numeric values of the IP address.
Press m or M repeatedly to select the
digit that you want to set.
6
Press ENTER.
"SUBNET MASK?" appears.
7
Press ENTER again.
The currently set subnet mask appears.
8
Press . or > repeatedly to enter
the numeric values of the subnet mask.
Press m or M repeatedly to select the
digit that you want to set.
9
Press ENTER.
"GATEWAY?" appears.
10
Press ENTER again.
The current default gateway appears.
11
Press . or > repeatedly to enter
the numeric values of the default
gateway.
Press m or M repeatedly to select the
digit that you want to set.
12
Press ENTER.
13
Turn off the connected AV system with
DIGITAL MEDIA PORT interface (Sony
DAV series, etc.).
14
Turn on the connected AV system.
To return to the automatic
setting
1
Select "NET SETUP?" in the network menu
(page 31), then press ENTER.
2
Press . or > repeatedly until "NET
TYPE?" appears, then press ENTER.
3
Press . or > repeatedly until "AUTO?"
appears, then press ENTER.
4
Turn off the connected AV system.
5
Turn on the connected AV system.
Restarting the network
unit
Select "RESTART?" in the network menu
(page 31), then press ENTER.
Naming the unit
(My Name function)
You can name the units for identification. After
naming a unit, the name will appear in the M-
crew Server.
1
Press MENU.
2
Press . / > until "NET SETUP?"
appears, then press ENTER.
3
Press . / > until "MY NAME?"
appears, then press ENTER.
4
Press . / > to select a desired
name from the preset names, then
press ENTER.
Tip
You can also create an original name. Refer to
"Additional Information" (page 37).
GB
32